Lord of the Rings Night Light; Doors of Durin; Moria - 8" tall, with added liner, and light vents on sides & top
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lord of the Rings Night Light; Doors of Durin; Moria - 8" tall, with added liner, and light vents on sides & top
- Ocena
- 4,5 / 5
- Polubienia
- 71
- Pobrania
- 237
- Wydruki
- 2
- Wyświetlenia
- 1468
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
Resized (reduced) to fit on my 220x220 mm print bed.
I remixed the case and added a “liner,” so the case can be printed with a darker color of filament while the liner can be printed in a reflective white filament.
I also remixed the case (and designed the new liner from scratch) to accommodate the LED bulb & cord linked below (Amazon), which also allowed for bulb changes without having to take the case apart or remove the art face. So, this means the case can be assembled by CA gluing the liner in, and CA gluing the art face in.
To facilitate its use as a night light I added some holes as “light vents” on the sides and the top.
Case (frame) update (May 3, 2024):
- I added a new v2 of the outer case that has the top slanted in, just like the sides. This should give about 25% more light from the back, to better facilitate use as a night light.
On mine, the artwork (face) is a one-color print (one filament, using Prusa Galaxy Black), however, you could also print the first layer in white and then do a color change. I like the one color print because when it's switched off, the runes are essentially hidden, which is a nice tie-in with the story.
No supports needed on face and inner liner. Tree supports were used on the outer case, but I added a support blocker to the light hole on the top. But that was on the v1 case. For the v2 case, tree supports should be fine for all three of the holes on sides and top that let light out the back.
Print as oriented (although see notes below about the artwork face).
I'm including two thicknesses of the face art:
- One is intended to print with 0.2 mm of translucent area (i.e. a single layer if you print it at 0.2 mm layer height). This is the one I printed.
- Another is intended to print with 0.4 mm of translucent area (i.e. two layers if you print it at 0.2 mm layer height). Normally I don't recommend this one as it limits the brightness.
Note about artwork face mirrored / non-mirrored. The artwork is currently mirrored (just as the original that I remixed from) which works for my design, i.e. to print with the translucent layer facing out. If you (for some reason!) wanted the translucent layer to be on the back side, you should flip the artwork face in your slicer to “un-mirror” it.
Designed for this bulb and switched accessory / lamp cord (Amazon affiliate link):








Change Log
- May 3, 2024 - added a new v2 of the outer case, which has the top slanted in, just like the sides. This should give about 25% more light from the back, to better facilitate use as a night light.
- May 2, 2024 - initial upload
My PayPal tip jar: https://paypal.me/design8studio