1 / 3
Remix of Qidi Cutter V2.0 body for Q1 Pro — zdjęcie 1
1 / 3

Remix of Qidi Cutter V2.0 body for Q1 Pro

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A remix of Marc Prudhomme's design of an inline filament cutter for the Qidi X-Max 3/X-Plus 3 to fit the Q1 Pro.

Ocena
4,667 / 5
Polubienia
156
Pobrania
1117
Wydruki
3
Wyświetlenia
7333
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I came across @MARCPRUDHOMM_1986375's excellent design for an inline filament cutter designed to fit the Qidi X-Max 3/X-Plus 3 models, but found it didn't quite suit my Qidi Q1 Pro.  The longer tube on the bottom of the original body did not fit into the print head, and I wanted the cutter to be held in place but also easily removeable.

I've altered the design of the body of the cutter to slip onto the plastic piece that holds the reverse Bowden tube onto the print head.  The “snug” design sits quite low down to the print head, and it can make it difficult to remove the print head.  The “space” design leaves a lot more space between the body of the cutter and the top of the print head, so removing the shroud is much easier.

The remaining parts should be printed from the original design, linked below.

https://www.printables.com/model/848262-qidi-cutter-v20-for-x-max-3x-plus-3-uses-9mm-snap

Please follow the original creator's instructions for printing and assembling the cutter.

Tagi