Proto-Scissors | Functional (proof of concept)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here is a functional (to an extent) pair of printable scissors
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 95
- Wydruki
- 0
- Wyświetlenia
- 417
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Description:
Here is a functional pair of scissors (to an extent)
I haven't done too much testing on durability, but they can cut through paper, cardboard, and masking tape.
Could be better if printed with PETG.
Let me know what you think!
I designed these with SolidWorks and printed them on my P1S
The use of super glue on the the pins will prolong the life and proficiency
Settings:
0.1 mm Layer Height
100% Infill
2 Walls
20 mm/s Initial Speed
Snug support
No brim or raft necessary (if build plate is clean)
No other modes
Assembly:
First, remove the support from underneath “Scissors O”
Put the Angled Spacer in the hole it belongs
Like so ^
Next, insert “Pin F” into the top of “Scissors O” so that the flange is flush with the edges
It will stick out the bottom like so ^
Add “Scissors X” on top and place it at an angle
Add “Pin M” to the other side
Use some form of help to push the two pins together. In my case, I used my channel lock wrench
And you're finished!
Enjoy!!