Swamp monster head
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Head off of a halloween prop that we made many years ago.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 176
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial
This head is made from a foam head (wig form) with some forgotten form of clay added to it along with some plastic teeth and tongue and glass eyes.
It was scanned with both the 3DMakerPro Moose scanner and the Seal scanners. The Moose scanner had a hard time scanning inside the mouth so I used the Seal scanner to capture that portion. It came out okay but the mount portion is a little messy. I should probably have exported those point clouds to CloudCompare to clean them up but I didn't want to spend the time on it.
Overall this scan would require some post processing to make it a good reproduction. The glass eyes did not scan well, the right nostril is not as round as the original and the mouth has too much noise in it.