PS3D Pulse Width Modulation Module (PWM)

*****WARNING*****

This project is documented as best as possible.

If you do not have electrical knowledge or do not feel confident following a wiring diagram please do not try.

There will be alterations of UL certified electronics.

This unit will have exposed wires and capacitors that could hold a charge. Please allow for proper de-energizing before handling any electronics in this project.

Proceed with caution and know this is something dangerous. I am not liable for any damage or harm done to yourself or property.

Handling energized power sources can be dangerous and should be handled with care.

Proper Personal Protection Equipment (PPE) should be worn at all times while using this unit. Eye protection could aid in preventing harm from solder splatter or exploding electronics.

Fume extraction should also be used while soldering.

*****End of Warning*****

The PS3D PWM Module is a useful external unit that allows you to provide power to a blaster via a coiled cable. You can have a higher voltage or mAh battery that can be stepped down to the correct voltage for a specific play style. 

Wiring diagram included as an image.

Some disassembly is required for the PWM module. Removal of the housing has to be done. Refer to photos as example.

BOM:

• 1 x Cigarette Lighter Extension Cord 12V - https://a.co/d/b13v9un 
• 1 x PWM DC Motor Speed Controller Switch Control 7-70V 30A Fuse - https://a.co/d/dDCErCt 
• 1 x 12V Blue LED Lighted Toggle Switch 30 Amp 12 Volt Toggle Switch SPST ON Off 2 Position 3pin https://a.co/d/hrI4zL4 
• 1 x 10pcs XT60E-F Female Plug - https://a.co/d/7QXJCNn 
• 1 x 10PCS XT60EW-M Male Plug - https://a.co/d/8T0PWgn 
• 1 x Molle Pouche - https://a.co/d/dH4MASD 
• 4 x M3x5mm Screws for Main Lid
• 2 x M3x15mm Screws for Potentiometer Lid
• 4 x M3x6mm Screws for XT60 Cable Savers
• 4 x M3x10mm Screws for XT60 Cable Savers