Parrot disco camera and belly protection
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After a hard landing and a camera crash, I decided to make this nice armour for my next camera. But the initial design…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 404
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
After a hard landing and a camera crash, I decided to make this nice armour for my next camera.
But the initial design was too big for my Prusa and difficult to print...
I finally cut the end of the tail and spillted the stl into two Left/right parts that you can print easily and then epoxy glue.
The filament lines are on the long edge which is good for strength as it is also in the landing direction !
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
No
Supports:
Yes
200
Infill:
40
Filament:
no name PLA
Category: Mechanical Toys