Radxa Rock Pi 4C+ Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A very average, fully functional case for use with 40mm fans (both 10mm & 20mm height). Original by xjo26.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 189
- Wydruki
- 0
- Wyświetlenia
- 1391
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Simple case for the Rock Pi 4C+. Enables you to use your Pi either passively or with a 40mm 5V fan of up to 20mm thickness. In case you got very chonky heatsinks the taller case part with a 10mm fan will most likely work for you.
You need 4x M3 screws and possibly 4x M3 nuts to screw it together. The thicker case will need absurdly long screws, however it will most likely also work without using the nuts by simply screwing it into the screwholes.
Strongly recommend not using PLA for this! The heatsinks inside will get way hotter than 60°C. I strongly recommend going with PETG or ABS to protect your hardware.
Dust filter shown in the photos not included, those can be found over here.