FNIRSI FNB58 USB Tester Storage Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Storage case for the FNIRSI FNB58 USB testing device.
- Ocena
- 5 / 5
- Polubienia
- 64
- Pobrania
- 368
- Wydruki
- 4
- Wyświetlenia
- 1426
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This storage case fits the FNIRSI FNB58 USB multi-meter/tester. The only extra hardware required are four 5x3mm magnets (which measured closer to 5x2.7mm for me). The holes are oversized enough that they will need a dot of superglue to hold the magnets in place, however they should sit just below the surface once glued in.
A piece of filament is used as the hinge pin.
The fit is snug enough to minimize rattling around, but still has enough clearance to use the finger slot on the right side to pull it out.
I have uploaded two models for the lid: one with “FNB58” on top (as shown in the pictures) and another without the text. The text is two layers thick if printing at 0.2mm layer height and I had no issues bridging over it with OrcaSlicer. Print lid top-side down.
Print Settings:
- 0.2mm layer height
- 15% infill
- 3 walls
- No supports
Printed with Flashforge Burnt Titanium PLA on a fractal pattern PEO buildplate.