Ratrig Stronghold Pro Dust Boot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Simple Dustboot for the Ratrig Stronghold Pro with a removable magnetic base. EDIT: Added STEP File
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 102
- Wydruki
- 0
- Wyświetlenia
- 704
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple dustboot for the Ratrig Stronghold Pro with the 80mm Spindle with around 20mm height adjustment
You will need the following consumables
24 x 6mm Dia x 5mm long magnets, i used these from Aliexpress
Dust Brush 70mm high, i grabbed a 1mtr length of Aliexpress
4 x M3 x 6mm Bolts for faceplate, Model has M3 modelled threads
Glue, i just used shoe glue, a cheap flexible contact glue, and clamped it the recessed area overnight.
4 x M6 x 10-12mm hex bolts fit into the spindle mount, it is a tight fit, so 10mm would be better for access, or look at a low profile knurled head bolt.
100mm / 4 inch hose hoes and hose clamp.
The magnets should be a firm press fit, i didn't need any glue to hold them in, when fitting, make sure you get the polarity correct on both parts, i tapped them in with a small wooden mallet, so i wouldn't chip them with a normal hammer
The faceplate is removable, so you can do your own thing, i added a blank model, so you can remix and add anything you like, its your machine, go nuts.
I also added a revised scaled down RatRig Logo version of the faceplate, The logo is from DJ_Designs, and i received permission from the designer to share it.
https://www.printables.com/model/309248-ratrig-logo-dxf-files
When i comes to printing, i would look at adding some supports for the area between the spindle hole and the dust port.
Use your own judgement when it comes to perimeters and infill, i used 3 perimeters and 30% infill.
I didn't add any supports for the magnet areas and they printed fine on my Prusa MK3S+ in PETG.
As for material, I pretty much only use PTEG, so i don't know how well it would handle with PLA
Anyhow, enjoy printing, post a photo of your print, hopefully you will have less dust around after.