Wacom Pro Pen 2 Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a holder for the Wacom Pro Pen 2. It has Nibs and collar storage inside, as well as nib remover on the rear
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 342
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
Patreon - https://patreon.com/CosmicNimbusPrinting
Cults3D - https://cults3d.com/en/users/CosmicNimbus
Hi !
I needed a new nib stand for my Wacom Cintiq Pro 13. After a look around, I found Bad Voxel's design. After printing it I realized it was for an older pen and the tolerances where very tight so I would have had to change to a smaller nozzle to print it.
So some time and iterations later, I've made this version that works with the Pro Pen 2. I took inspiration from the new style holders, and flipped the screw design so it will print with no supports. I also tightened up the nib slots, added more slots for more nibs, and included the hole in the bottom that you can use to remove the nibs from the pen.
Printed at 0.12mm layer height, with a 0.4 nozzle on my Ender 3 V2 Neo.
Happy printing !