Filamentholder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a better design on my enclosure to hold and change a filamentspool. I have made a design with 2 bearings.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 88
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Dear Fellow 3D printers
When I saw the light and after some research on the internet I came to the conclusion to buy a printer.
It was a Prusa MK4, yes, the kit version.
After 1.5 days of toil and sweat he was put together and after the necessary actions he worked.
All I needed was an enclosure, it was needed to be at my school.
On the internet, on the site of Prusa, I believe, I came across a system with 3 Ikea Lack tables.
After the necessary modifications, it was put together.
I was just not satisfied with the filament holder with small rolls that came on the top Ikea lack table.
Hence this design, which you can mount on a plate or in my case on the top Ikea lack table.
The only thing you have to buy in this design are 2 bearings (via Amazon or something (outside dia 22mm – inside dia 8mm with a thickness of 8 mm)).
Print in PETG because of its strength. Print the spool horizontally and give it organic or snug support, then finish it with sandpaper.
Simply print the filament holder upright without support.
S6 and Regards, Bert