Industrial Sewing Machine Cone Thread Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted an inexpensive way to add more thread to my industrial sewing machine and not the flimsy little metal rods…
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 1312
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
I wanted an inexpensive way to add more thread to my industrial sewing machine and not the flimsy little metal rods that come with them.
This might not be something that everyone can use - but the idea can be useful for other things.
A standard 1/2" Sched 40 T fitting is a perfect fit for my thread-stand pipe. I tapped a hole in the side and added a bolt so I could tighten it (though it doesn't really need it).
I added a horizontal 1/2" pipe and two more T's with uprights just a bit longer than the cone height.
The cone stand fits snugly over the T's and fits a cone thread holder much better than the thin metal rods that are normally used. This should fit most industrial size thread spools (1/2 lb and 1 lb spools).
I have a small sample saddle you can print to make-sure your prints and pipes match-up. I'm sure a small scale up/down would make a perfect fit.
Please comment/post a make if this helps you out.
Print Settings
Printer:
FLSUN i3 2017 Version
Rafts:
No
No
Resolution:
.2
25%
Filament: Hatchbox PLA Blue
Notes:
Print upside down so the open-end is up. It prints great without support. Depending on your bed adhesion you may want to add a small brim to help it secure itself to the bed.
Category: Replacement Parts