60 Degree 3 way PVC Coupler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My original filament spool holder broke - but I liked the threaded-rod and clamps I made - so I needed something that…
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 107
- Wydruki
- 0
- Wyświetlenia
- 1007
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
My original filament spool holder broke - but I liked the threaded-rod and clamps I made - so I needed something that would hold a 16mm (5/8" OD) axle that my filament turns on.
This is sized for 1/2" Sched 40 PVC for the legs and 5/8" for the pivot point. In my-case it's a 3d printed threaded nut that all-thread goes into.
I may update with end-pieces if I find I need them for the bottom - rather than cutting the PVC at an angle.
I think I have this designed just right for printing - in my case I did not need any supports and only a little clean-up on the inside. It's a snug, but not super tight fit.
UPDATED: 2019-01-17
Added Rev4 which is a bit tighter. Depending on your printer the v2 version may be a bit too loose.
Added the 16mm spacers I used which will thread onto 3/8" all-thread. You can guy 3/8" all-thread at the big-box stores for cheap. The Metric all-thread is expensive. I chased the threads with a tap to clean them up - they spin very nicely.
I decided not to print end-pieces. I just printed 2 extra brackets so I can make a small stand. This gives me some options for the new filament holder. I'll update with pics of the final filament holder when completed.
Print Settings
Printer:
FLSUN i3 2017 Version
Resolution:
.2
25%
Filament: Amazon Basics PLA Red
Category: 3D Printer Accessories