MMU Bleed Test
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small disk with a dot on the side to test purge volume setting and color bleed.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 440
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
I printed Minion Dave in 5 colors to torture my MK4/MMU3 setup, and I noticed black bleed into the yellow body, so I designed this small cylinder with a dot on the side so I could load main.stl and dot.stl into PrusaSlicer at the same time and try different colors and purge volume settings in a smaller model that doesn't take too long to print.
The first image shows the results printed with different purge settings. On the left side is the default 65 then 130,243,250,400,800 (the 243 was an experiment setting the default for all filaments instead of just the black to yellow transition). It might not show up in the photo, but there is faint bleed through on almost all the settings except perhaps the 800.
Note: PrusaSlicer, for God knows what reason, insists that the dot.stl looks like it should be in inches, not millimeters, tell it NO.