1 / 2
1/2" EMT Coupler (RepRack) — zdjęcie 1
1 / 2

1/2" EMT Coupler (RepRack)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simpler coupler for 1/2" EMT Conduit / Tubing as used in the RepRack.

Ocena
0 / 5
Polubienia
17
Pobrania
112
Wydruki
0
Wyświetlenia
308
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution

After installing my reprack at 64" (4 US standards stud spacing), I realized that I needed 96", but had already cut all 8 of the ½" EMT conduits. I needed a coupler for EMT and could not find one online.

PRINT ON SIDE WITH SUPPORTS!

This must be printed on its “side” (long ways on build plate) to not involve layer adhesion in the strength. I printed with Elegoo Rapid PETG (love the stuff). Still, no matter what I did, the bottom half never came out as clean as the top half. They work fine still, and I'm learning more.

I was unable to break a coupler with a 16" piece of EMT attached to each end. They are incredibly strong if printed as intended.

 

Nozzle: 0.4mm

Layer Height: 0.2mm

Wall Loops - 4

Infill - 50%

Support - Yes, with 50 degree threshold angle (I found this a good compromise for quality)

Tagi