PSU Holder under Prusa Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for PSU under Prusa Enclosure together with higher feet for Enclosure, which I also have model for.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 163
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I did not have enough space behind my printer. I was able to make room under the Enclosure. So together with higher feets that I have, I also added holder for PSU.
Now when I need to take my printer out, I just need to disconnect power cable and that is all.
For the bottom holder I used double sided tape, just in case. The holder is just a few mm above the “ground”, so even if the PSU will be too heavy for the holder, it doesn't matter, it can just sit on the “ground”. But for moving the printer, it holds pretty well :-)
I printed that from PLA, 0.2mm with 0.4mm nozzle. For assembly, I would suggest to mount the front holder (where the cables will be), put in the PSU and then the second holder and mount it. Mouting is from the inner of the Enclosure, so it is no issue to do it with PSU inside of the holders.