Stealthburner CW2 LGX Lite Mellow SB2040V3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stealthburner CW2 mod for the LGX Lite and Mellow SB2040V3 Canbus board.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 123
- Wydruki
- 0
- Wyświetlenia
- 1401
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
A mod of the Voron Design Stealthburner and Clockwork 2 extruder designed to suit the Bondtech LGX lite / LGX Lite V2 extruder and Mellow SB2040V3 Canbus board.
The Mellow SB2040V3 is quite different to the V2 designs and uses a new design fan board.
Main extruder body section is based on Bondtech's single piece LGX Lite Clockwork 2 mod.
Also included the Stealthburner front fan housing from the BTT SB2040 by @garethky_1988 because of its wider housing
Lots of different cable chain / PG7 cable gland / CNlinko connector mounts will work with it as normal. You will need to choose one to suit your install.
Its recommended to use a cable door with a fan mount to provide cooling for the board. This model by @Mloeko https://www.printables.com/model/348581-voron-stealthburner-lgx-lite-mellow-sb2040 will work but obviously does not fit perfectly. I might do one that fits better but didn't see the point of redoing work just because its not a perfect match. I am using it with a 3006 fan just fine.
Hardware Needed:
- 4x heatset inserts (more may be required depending on your specific configuration)
- 4x M3x12 BHCS or SHCS to mount LGX Lite
- 2 x M3x5 countersunk screws are needed to mount the PCB holder
- 2x M3x5 screws of some type are needed to mount the SB2040V3 PCB