Hinged Corner for PVC Gates w/ vertical

This model is copied from thingiverse and was made by ReflectorBB and submitted on September 17, 2018:

"Update Kwmachine (the original designer i remixed from) has made some vertical versions of his hinge, the look good, and considering he made the original i would check his out first

I used Kwmachine's gate hinge as a guide to build this hinge.
We wanted to replace using PVC T junctions as the original hinge was very convenient. This allow you to put another gate or pole above the ground level gate. (vertical double gate)
And when i was building the last one (32mm) i realized that i didnt need to model the short part, just the modified tall part. How much time i could have saved, oh well it was good practice.

We were finding 1/2" PVC pipe but we were finding its too flimsy,
i have not yet printed any other sizes to test, but they look like they should slice ok (i sliced in cura to check for problems)

Imperial:
50 = 1/2"
75 = 3/4"
1 = 1"

Metric:
20mm
25mm
32mm

The spine along the vertical portion was reinforced and held up well to several hits, both directly and indirectly (when someone hit the pole well above the hinge)

I used sainsmart TPU to print these with 6 walls and 50% concentric 3d infill (cura)"