Mad Merv's Weed Eater Sled Runner Revision 2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A guide you can bolt to the rear of your weed eater to help cut at a specific height
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 732
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Share Alike
You can print one or a pair. You can bolt them together, and bolt them to your string trimmer's shield. You can bolt them to the sides, or the back, depending on what kind of string trimmer you have. You can also bolt just one on. It helps you cut everything to a specific length. Use finger screws so you can remove it when you are out “in the field” ha ha – bolt four on so you can go left and right not just forward and back.
You may need to scale this to your desired length. You can drill the holes bigger if needed. Model was exported in low-fidelity mode from Shapr3d
Check out Revision 1 for an alternative design: https://www.printables.com/model/873241-mad-mervs-weed-eater-sled-runner-revision-1