Insert for El Burro board game (by Spielworxx)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick insert that fits everything neatly into the box - with some caveats
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 93
- Wydruki
- 0
- Wyświetlenia
- 369
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Noncommercial
A quick insert for El Burro Kickstarter edition.
Everything fits with zero lid lift - in fact I packed the bottom of the box with the leftover frames after punching the tiles.
The card caddies are sized for Sleeve Kings sleeves (60 micron); 90 micron sleeves might fit.
I ignored the cardboard feet and instead opted for some 6mm diameter clear rubber self-adhesive feet. I positioned them quite carefully so that the feet would fit into the “wells” of the board below. But if you have gone with the cardboard feet, everything should still fit in the box (but toss the leftover frames).
I'm pleased with the setup tray; less pleased with the solitaire tray (but I never play solo, so it was an afterthought - someone might want to remix it to provide greater usability).
Ditto the player trays - I had intended to do something more ambitious, but TinkerCAD deleted my entire design, making rebuilding everything from scratch a chore. Luckily I had sent all the files to the printer by then, so I was still able to upload it here.
Also luckily I have quite a lot of filament so I could print everything in appropriate colours.