Case for the Artekit 3.3V/5V USB-C power supply
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for the Artekit power supply, hole for pins on the bottom, no screws/glue/supports, clipped together
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 305
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This model is a case for the “Artekit 3.3V/5V power supply with USB-C connector”, see https://www.artekit.eu/products/accessories/power/ak-usbsupply-c/
The power supply is assumed to have three pins soldered to the bottom so that it can be connected e.g. to a breadboard.
The case consists of three parts:
- The body with floor and side walls. The PCB is press-fit onto the floor of this part. The soldered pins go through the hole in the floor.
- A holder part which prevents the PCB from being pushed upwards. It is placed above the PCB on the side of the connector pins (NOT the USB plug) and held in place by two bulges attachted to the body's side walls.
- The cover on top. It slides from the USB plug side of the case
The case holds together by two clips keeping the cover on top of the body. No screws or glue is needed. The clips can be pressed inwards through two small openings in the side walls to open the case in a non-destructive way.
The model contains three files:
- OpenSCAD source code with lots of comments and explanations
- STL file generated from the sources ready to be printed
- 3MF project for the Prusa MK4