"Stanley" style mug for 3DSets Rancher

Recently finished my 3DSets Rancher Hardtop, and my wife fell in love with it. 

She took a look inside the interior, and was surprised to see how detailed it was, especially with the fact that it had cup holders.

Jokingly, she said, “You should make my big ass Stanley tumbler that I carry and put it in the cup holder!”

Challenge accepted!

So, I modeled this. It's 2 parts, printed in PLA; it WILL need supports for the handle and for the lid due to the lip, and the mug is likely going to need a brim just to be safe.

The bottom portion of it fits nicely into the front cup holders, and I'm glad I gave it enough depth to really sit in there - if you start bouncing around, it's not going to come out unless you roll the Jeep!

I've also included two different lids for the mug; one has a higher brim to it than the other, and aesthetically, it didn't look quite right to me, so I shrank it down a bit so it didn't look quite so tall. Both are available, print whichever you like!

Printed on a Prusa MK4 at 0.15 SPEED with IS; probably could have done it a little slower and the straw might not have come out so bumpy, but considering the size and where it's going to sit, I'm not worried about it. :)