Delta-V (dual Delta P) v3.2 for MK3S+

***Replaced by the Delta-V v4.3!****

https://www.printables.com/model/895278-delta-v-dual-v43

After taking all of the wonders of dual fan modifications and the Delta P extended model, here is their lovechild. designed to be significantly more compact and sightly than the two front facing fans, with better mounting (via Delta P cover).

Delta-V shroud utilizes the original Delta P mounting and cover (in files)

Needed prints: Delta-V Dual v3.2.stl,  7mm bushings (2).stl, V2R2.2 cover.stl

Needed hardware: 2x m3x40 screws (normally used in extruder assembly), 2x Prusa 5015 5v 3pin blowers, 3x M3 hex nuts, 1x M3 square nut

Printing: I used my 0.25 speed profile in PETG with good results, but i would recommend following the original print spec for the Delta P. Pointing duct entrances to the rear of the build plate (pictured) shaves a few minutes off print time.  

Needed Tools: 2.5mm allen key, soldering iron, wire strippers, clean and steady hands.

Wiring Rear Fan: Wired proper through the harness. 

Wiring Front Fan: The outer fan has about 6" of wire length (looped behind the PINDA wire loop) and the ends are soldered to the first fan which you can find after removing the rear sticker. ONLY the black and red wires are soldered into the first fans contacts with their respective colors, and the PWM signal wire(white or yellow) is cut 1" shorter and not used. The RAMBO board can only read one PWM signal at once. Using the second white wire will cause errors.  

Assembly: Disassembly and Cover instructions from the original Delta P are the same except for the last step. Instead of one fan, its two and the 2x 7mm spacers are meant to be placed in between the two fans at each mount hole.