1 / 5
Tesla Model S -2021: Halterung für die Hutablage — zdjęcie 1
1 / 5

Tesla Model S -2021: Halterung für die Hutablage

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ersatzteil für die Halterung der Hutablage beim Tesla Model S bis BJ 2021.

Ocena
0 / 5
Polubienia
12
Pobrania
69
Wydruki
0
Wyświetlenia
476
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

Oft scheren bei der Hutablage des Tesla Model S die Haltenasen ab, wenn Sie von unten Druck bekommen. Als Ersatzteil bietet Tesla nur die komplette Hutablage an. Aus diesem Grund habe ich die Halterung nachkonstruiert und die Pins flexibel und herausnehmbar gestaltet.

Als Material für die Halterung habe ich „Greentec pro“ von extrudr verwendet. Dies Material ist hoch hitzebeständig, was an der Hutablage bei Sonneneinstrahlung sehr wichtig ist.

Für die Pins habe ich das TPU „Flex hard“ ebenfalls von extrudr aus oben genannten Gründen verwendet. Es sollte aber auch jedes andere TPU funktionieren.

Wichtig bei den Pins ist eine 100% Füllung im Bereich des Stiels. Die Pins halten durch den Konuswinkel von 2% und sind die , bei starker Krafteinwirkung (z.B. Hund im Kofferraum der sich aufrichten will) die Sollbruchstelle des Systems. Die Pins sind in diesem Fall mit einem Handgriff ausgetauscht.

Eine bebilderte Einbauanleitung ist in der Datei “Anleitung de-en.pdf” zu finden

 

The retaining lugs on the parcel shelf of the Tesla Model S often shear off when pressure is applied from below. Tesla only offers the complete parcel shelf as a spare part. For this reason, I have redesigned the holder and made the pins flexible and removable.

I used "Greentec pro" from extrudr as the material for the bracket. This material is highly heat-resistant, which is very important on the parcel shelf when exposed to sunlight.

For the pins, I used the TPU "Flex hard" also from extrudr for the reasons mentioned above. However, any other TPU should also work.

It is important that the pins are 100% filled in the area of the handle. The pins are held in place by the cone angle of 2% and are , the predetermined breaking point of the system when a strong force is applied (e.g. a dog in the boot of the wants to stand up). In this case, the pins can be replaced with a flick of the wrist.


Illustrated installation instructions can be found in the file "Anleitung de-en.pdf"