1 / 10
TRV602 TRV604 Thermostatic Radiator Valve 18650 battery conversion kit — zdjęcie 1
1 / 10

TRV602 TRV604 Thermostatic Radiator Valve 18650 battery conversion kit

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter mod to use 2x 18650 battery in 1S2P configuration on a TRV604 WIFI radiator valve Also for TRV602 ZigBee

Ocena
0 / 5
Polubienia
5
Pobrania
26
Wydruki
0
Wyświetlenia
495
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

Here is my take on converting the 3x AA batteries into a dual 1S2P 18650 rechargeable battery for my TRV 604/TRV602

My TRV604 are mounted on Danfoss RA valves.

I used around 60 AA batteries in 6 months with these thermostatic valves.
I wanted something that lasted longer and that was rechargeable. I could have went with 1.2V NIMH batteries but they drain too fast and take long to charge.

To build the adapter you need:

1x TP4056 micro-USB protection circuit
2x (or 1) 18650 battery cell
4x approx 15cm pieces of single core hard copper wire 
2x M3x5mm machine screws (for the battery terminals/holder)
2x M3x15mm machine screws (for the AA contact terminals)
2x M3 nuts (for the AA contact terminals)
8x M3 washers (for spacing and wire attaching)
1x M2.5 or small self tapping screw to hole the TP4056 in place. 


1-Screw the Battery holder and the 3xAA adapter together with M3x5mm screws.
2-Strip the copper wires and wrapping them around the battery holder as per the pictures.
3-Solder them onto the TP4056 module as per the colours of the picture.
4-Wrap the OUT+/OUT- wires around the M3x15mm screws and squish it with the nuts and washers
5- Charge the 18650 INDIVIDUALY fully with the TP4056 module (to avoid 1 battery  cell discharging into the other with a huge current)
6- When both batteries are charged, placed them both into the battery holder and charge again.
7- Install the battery module in the TRV604 and recalibrate the valve
8- Install the cover piece.
9- Profit !

The Lithium is 4.2V fully charged and 3.7V for the majority of its charge lifetime. Which is enough for the TRV604 which indicates 0% battery at around 3V. 
You should therefore benefit from the greatest span of the Lithium battery range.

This was all printed in White SUNLU PETG on both my Ender 3 and K1 Max.

Tagi