Ford Focus Mk1 Hatchback Parcel Shelf Hanger Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement part for the part that connects the parcel shelf pivoting lanyard to the trunk trim piece.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 136
- Wydruki
- 0
- Wyświetlenia
- 1075
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Definitely not perfect, but it at least fit my broken part to start with. Will look to improve if it doesn't work for a while.
This should work on any Mk1 Ford Focus Hatchback, at least the North American versions. B4V0A and POM are printed on the original. I can't find the actual part number though.
Potential improvements:
- The part that clips in (I call it the “wedge”) doesn't fully seat / partially hangs out. Ideally it could be turned in place a little and won't fall out at all, but still be removable. Alternative would be to emulate how the original clips in.
- Increase the gap between the top of the clip and the bottom circle, since it can't be turned with the current design.
- Increase the top width of the “wedge” so it fits in more securely, but too large and it won't fit (like the Thingiverse model I tried below)
- Sphere on top could be slightly larger, but not much, to clip in better.
Originally printed in Overture Sparkle Blue PETG with 0.2mm layer height. You definitely need supports, I printed with the “wedge” on the bottom and enabled tree supports. Didn't come out super pretty, there might be a better way.
Loosely inspired by https://www.thingiverse.com/thing:4864137 and https://www.printables.com/model/474994-trunk-cover-lanyard-snap-ford-focus-st/