Metabo C12RSH2S dust shroud
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This shroud allows you to plug two 2.5 inch hoses to your miter fence eliminating the vast majority of dust cloud.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 99
- Wydruki
- 0
- Wyświetlenia
- 1004
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
How to print
- Print the ports with the flat face down. You are going to need to rotate the model by 30 degrees to make it lay flat or use the ‘lay on face’ feature within your slicing software. You are going to need a small amount of support around the edges.
- Print the shroud upside down as shown above. No supports needed.
How to install
- Slide the ports into the shroud. Use of super glue is recommended.
- Remove the miter fence that came with your saw
- Cut 2 pieces of wood to fit into the miter fence slot. The dimensions are shown below.
- Place the printed shroud in between the new fence. Bring the blade down and align it with the kerf slot as best as you can.
- Butt everything up tight against each other and screw the shroud into the new fence from the back. There are four countersunk holes.
- Tighten the knobs on the back.
Results
The results are fantastic. The miter saw went from the most messy tool in my garage to one of the least messy tools.
Limitations
CR12RSH2S has a 45 degree miter to the left and 60 degrees to the right. When you use 2.5 inch hoses you will not be able to utilize the full 60 degree miter capacity because the hose will be in the way. In this scenario, you are going to have to remove the shroud and use the default fence instead.
Alternatively, you can use a single 2.5 inch hose on the right side at the cost of a reduced airflow. Since the saw moves only by 45 degrees you will not lose any miter capacity in that direction. This approach is also convenient in that you can set the whole fence assembly one time and not have to undo any hoses. I have not measured the performance differences between 1 port vs 2 ports. I am currently rocking the 2-port version and am happy with it. I will update the post if I ever decide to switch to the 1-port version.