Gridfinity Micro-Mark Micro Punch Set holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gridfinity Micro-Mark Micro Punch Set holder.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 1
- Wyświetlenia
- 140
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a Gridfinity holder (1x2x3u) for the Micro Punch Set from Micro-Mark. Example shown is printed on an Ender 3 V3 SE based in Standard mode with a .04mm nozzle using IIID Max (Yellow) filament
NOTE: Make sure your Hole Horizontal Expansion (Cura) setting is properly adjusted. There was too much play from my normal hole tolerance adjustment of 0.60mm, so the tolerance adjustment per hole on this (for the punches) is only +0.20mm. You may want to use the included test gauge to make sure the holes are big enough to accomodate the punches. The rectangular hole for the guide plate and die are set to the usual +0.60mm tolerance adjustment.
Obligatory link to Zack Freedman, who has made it possible for me to finally start organizing my workbenches with his Gridfinity system. Thanks, Zack!