KLP1 internal spool holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A spool holder to keep filament inside the printer. You can have up to two, one for each side.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 97
- Wydruki
- 1
- Wyświetlenia
- 859
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
A spoolholder to print in pairs and to add to your KLP1 (original version, not the the one with the 230x230 bed plate).
Print it in PETG, ABS or any material with a good resistance for the temperature you can end up with inside the printer. I suggest a wider layer width like 0.6 or even more.
Secure it with some double sided tape to the bottom of the printer.
Only for spools with the internal diameter bigger than 56mm (55 if you trust your tolerances). Depending on the format of your spool, you might have to print an additional step-down ring to run it smoothly.
The hole in the rod is designed to fit many of the cheap temperature/humidity sensors you can find around. For example: https://www.aliexpress.us/item/1005004406263759.html