Drink Dipsenser Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Base to hold a drink dispenser up so you can fit a cup under the nozzle
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 160
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
The wife bought these cheap 1 gallon drink dispensers for an upcoming party at WalMart for $5 each, but they did not come with a stand or base so that you can't get a cup under them (unless they're on the edge of a table). I designed these in tinkercad and printed up a couple. Holds the dispenser up high enough to fit a solo cup under and pour a drink. It also is printed in 2 parts where the top part (the tray) has a lip on the bottom to snugly fit over the base so it doesn't slide off and it also has a lip around the top to hold on to the the dispenser to keep that from sliding off the side.
Supports are required for the top piece as there is a lip on both the top (to keep the jug from sliding off) and the bottom (to keep the top from sliding off the base). Print the base portion upside down and no supports required for that.
Printed with a .4mm nozzle and a .2mm layer height in PLA
This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/08xIXpYijyF