Star Wars Legion Minature holder

As I equipped my minatures with acrylic bases and did not want to incorporate magnets for some storage, I was looking for another method of keeping them in place during transport.

This is what I came up with.

-= UPDATE 27.02.2023 =-

There was an issue on the top part where the slot for the slider wasn't long enough for them to open properly (on the left side).

Sorry 'bout that!

If you already built it with the old top part (like me), you might need to sand down the sliders with a dremel or similar

-= UPDATE 28.02.2023 =-

Squad_7_top_v2 includes the fix for the lacking space for the slider but also reduces the height of the alignment pins by 0,5mm.

-= UPDATE 30.04.2023 =-

Adding holders for bigger bases: 50mm x2 [top|bottom]: Holds 2 5mm bases (like the 74-z Landspeeders) 70mm [top|bottom]: holder for a 70mm base 100mm 2hole [top|bottom]: holder for one 100mm base and 2 equipment upgrades with 2mm pins 100mm 4hole [top|bottom]: holder for one 100mm base and 2 equipment upgrades with 4mm pins 100mm [top|bottom] AT-ST: Same as 100mm_4hole but bigger to cover the entire footprint of an AT-ST

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3

Rafts:

No

Supports: 

Yes

Resolution:

0.15

Infill: 

30%

Filament: Janbex PLA Black

Notes:

Supports needed for the sliders only.
Obviously, you will need 7 of them...

Post-Printing

Put the sliders in place and glue the top part onto the bottom...

Holes and pins will help align them properly