1 / 3
Lego Helical Gears 45 degrees 20t + 12t — zdjęcie 1
1 / 3

Lego Helical Gears 45 degrees 20t + 12t

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

45 degrees helical gears, Lego compatible

Ocena
0 / 5
Polubienia
51
Pobrania
293
Wydruki
1
Wyświetlenia
1172
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Engineering
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Imported from my designs on Thingiverse. Original upload was 31.10.2018 (dd.mm.yyyy)
 

Consider to follow if you like what I do.

Helical gears for Lego.

These are 45 degress.

Resin printers are better than FDM to make the gears smooth. FDM will work but you have to do the instruction below

Note this if you are using a FDM printer: You have to wear down the gears a bit before use in a vehicle/creation.

Build something like in the picture connect a motor to the smallest gear and let it run for 10 minutes. After that. Connect the motor to the bigger gear and let it run for some time until its smooth.

Print with 0.1 or lower.

I printed the 20t gear with 0.1 and 40% infill. 12t is printed with 0.05 layerH and 100% infill.

The gears gets really smooth if printed with 0.25 nozzle or smaller, but it will slide on the axle.

Tagi