Roxtec EZENTRY 4 Layout Template
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Layout template for Roxtec EZENTRY 4 electrical panel bulkheads
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 118
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
This is a layout template for Roxtec EZENTRY 4 electrical panel bulkheads.
I had a recent project that involved cutting openings in a bunch of electrical panels and got tired of laying them out by hand. This was my solution! There are cavities for 12mm x 3mm round magnets, with a pilot hole for an M3 x 4mm flathead screw (pre-threading is recommended), under the faux bolt heads. The magnets are not strictly necessary, but they do make positioning a lot easier!
Check out one of my other designs, "Bolt Head Fridge Magnet", based on the original magnet stanchions for this project.
Please Comment, or post a Make or a Re-make! Thanks!
Markings and Bolt Heads
To get the raised copper markings and silver bolt heads required two filament changes. I started with Black Silk, which I swapped for Copper Silk at layer 9 (assuming a .2mm layer height), then switched to Silver Silk at layer 11.