Frankford Arsenal Floating Die Blocks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These blocks take the place of purchasing the aluminum machined blocks sold by Frankford Arsenal.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 301
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I do a LOT of reloading and just purchased another single stage press, the Frankford Arsenal M-Press to supplement my progressive presses. So far I like the press and the ability to easily swap dies in a matter of seconds. What I don't like is purchasing so many of these die blocks. When using anywhere between 3 and 4 dies per caliber it can get pricey quickly.
What I have found so far is the die that puts the greatest load on these blocks is the resizing die. I have tested by resizing almost everything from .32 Auto to .44Mag cases and the blocks stand up well. I use carbide dies and do not lube those cases prior to resizing. I have yet to try any rifle cartridges yet, but those are all lubricated prior to resizing and do not expect any issues. I have used de-priming dies for everything with no noticeable problems with these blocks. The worst case being you may have to buy a few of the aluminum blocks if needed for resizing and use these for everything else.
A hole for a 8x32 screw is provided for a brass screw to lock the die from turning in the block.
Here are the settings that I used:
- .15 mm layer height
- .4 mm nozzle
- 75% infill
- 10 Perimeters
- Rafts: No
- Supports: None
- 6 Layers top and bottom
I used PLA+ to print these for the additional strength.