Harry Potter Magic Wand Elderwand Dumbledore
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Model of the Elder Wand from the Harry Potter series. This is a 2-part wand which goes together without magnets or glue.
- Ocena
- 4,8 / 5
- Polubienia
- 228
- Pobrania
- 2240
- Wydruki
- 6
- Wyświetlenia
- 6539
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial
Model of the Elder Wand from the Harry Potter series. This is a 2-part wand which goes together without magnets or glue. The joint isn't noticeable.
The assembled wand is 15" / 38cm long.
.02mm layers
2 walls
15% Infill
The print profile has it angled as it should be printed both to fit the bed as well as support. I used tree supports. You may want to slow this down. I set most of the speeds to a max of 50mm/s. The initial layer and support are faster as they are printed before it gets too tall.