Mini Sherpa Umbilical Strain Relief
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this simple strain relief for my mini sherpa (its a triangle labs SLS) mounted on my dragonburner.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 697
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Apparently I'm the only person who doesn't have a CANBUS board on my dragonburner. Had to design a simple strain relief for my umbilical, attaches to a mini-sherpa. I believe some mini sherpas have different dimensions, so mine is a trainglelabs SLS if that matters. I've included the STEP file so you can change any dimensions you need.
The spacers that connect to the mini sherpa themselves require a heat insert; however since the walls are so thin you need to reinforce them while placing the heat insert, or the thin walls will deform too much. I've added that file too, should just snugly fit around the spacer, and then you can pop it off after.