Hori Fighting Edge Cable Door Replacement (Hori FE PS4 + PS3)

Thsi is a remix based on the Hori Fighting Edge Cable Door which itself was a remix of the HORI Real Arcade Pro HRAP VX & V3 Cable Door.

Two modifications were made to the Hori Fighting Edge Cable Door model:
- Increased overall length by around 1mm to make the fit better
- Increased thickness of the pressure latch to lower risk of snapping after print

In addition to the above, two additional versions are provided:
- Version with Neutrik mounting slot
- Version with Neutrik mounting slot + 24mm button

My use case for this is to have an outside mounted Neutrik on both my Hori FE PS3 and PS4 without the need to drill or modify the case.

The use case for the 24mm button is to act as a function layer in the GP2040-CE firmware.

Please note that the set pictured here was done with a 0.4mm nozzle from Bambu.

I have tested this print on my Bambu X1C with the following changes to a stock configuration:
- 0.4mm nozzel
- 4 Wall loops
- 4 Bottom shell layers
- Honeycomb sparse infill pattern

It is recommend to print with supports as there is a small overhanging section on the latch.

Due to the overall small size of the print I would recommend just doing it at a setting which will do 100% infill with no pattern.

This was printed in matte black PLA from Bambu.