1 / 3
iDevice Organizer v2
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vertical stand for two MacBooks and an iPad.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 293
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (10)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (5)Powiązane
Updated to add v3 (Dec 18, 2021):
- Rebuilt from scratch
- Parametric design, number of laptops/iPads and the space for each is now handled with parameters.
- Uses less filament (less cost to print) than previous iterations
- Less surface area on the build plate has eliminated warping on my PETG prints
- Supports recommended, but brim is no longer necessary and cooling is ok.
Updated to add v2:
- The divider arms have been updated substantially:
- made uniform
- reduced in height
- fillet has been reduced to be more consistent with the idevices this is holding
- A chamfer has been added to the device slots
- The height of the base plate has been increased slightly
- If printing PETG, suggest the following settings:
- Infill 30%
- add a brim
- turn off cooling
I had challenges with the base warping right at the divider arms, which I believe has to do with the higher layers cooling and pulling at the base. Adding a brim and turning off cooling (and redesigning the model a few times) eliminated most of this. Winter weather and the printer being right next to a window was probably not helping here.