Tea Cup and Saucer wall mountable display hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount for a teacup and saucer
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 115
- Wydruki
- 1
- Wyświetlenia
- 980
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
Adjustable bracket for hanging tea cups and saucers on the wall. Designed for the Royal Albert Regal Series, but should work with others. (Those are my ‘daily drivers’)!
The holder prints as 3 pieces to optimize the fdm layer strengths, and avoids using support materials. The saucer arm piece folds up, and a collar slides over to keep it folded. The saucer collar isn't strictly necessary, but it's helpful if you're adding/removing the saucer daily. The saucer collar has a .2mm print helper attached to it. Tear off and discard the print helper. The edge of a table can be used to slide the collar over the hook. (Pictured).
The hook slides over the saucer post, and a nail holds both together. The head of the nail should not contact the saucer due to the saucer lip curvature. If it does contact the saucer, use a different hole.
Designed to use small nails found in cheap picture hanging kits commonly found in dollar stores. They usually have 1 ½" or 1" nails, either should work. The nail holes have a diameter of 2.3mm. The cup hook hangs over the higher nail holes, making making them hard to hit with a hammer. Instead of hammering, you can use the handle of a fork to push the nail into the drywall, or pre-make the hole and slide it in. (The thinking here is that if you have a wall full of teacups, you don't want to be hammering on it).
There are marks on the side of the cup hook to help with marking the wall if you want to pre-drill/punch the hole.
I've included a parametric design file so you can tweak the specs as you like. Please post your remixes!