Battery Cover with offset clip for BBQ Thermometer (Inkbird IBT-2X)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement battery cover for a digital BBQ thermometer bought from Amazon
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 132
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
2024 Update: I redesigned it for a tighter fit, this time I printed in ABS & sideways with supports.
I looked for existing models and used generators but none would suit. The main issue is the clip was not centred. I found a design on onshape that had similar features so I modified the dimensions. There was a bit of trial and error, After about 6 prints, I got to the point where it was good enough. it clips in and prevents the batteries from falling out. I used PLA and it's still going strong after 2 months. But I'd imagine PETG would be a better choice.
Here is my onshape model, if you want to modify it
Note my thermometer has been modified with magnets so I can mount it on my oven, and I've cut off the sensor holder to slim it down.