1 / 3
Dual spool holder - two filament spools holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a dual spool holder - consists of two parts, printed without supports and connected with four M4 bolts.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 222
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a dual spool holder - consists of two parts, printed without supports and connected with four M4 bolts. Simple and sturdy.
If concerned about potential sagging over time - the hole in the holder is made for the purpose of putting through it a long bolt with washers on both sides / metal tube / rod etc. However, it is optional.
I have printed it with:
15% infill
PLA
No supports
It takes ca. 230g of filament with those settings (for 2 parts printed at a time).