Hypercube Evolution (HCE) Extruder Mount with TronXY/Anet Sensor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
*Note: I will be up to make some minor changes for people but please don't request mounts for other sensors that are not compatible with the TronXY XY-08N or the Anet Z Probe.
I had rigged my sensor to the side of the original extruder mount but wanted a better solution. I put this together in 3 varieties. One to have the sensor on the left, one to have the sensor on the right and another to have it on the left with the mount bracket only 2mm thick instead of 3mm to allow wiring to come out the front on that side. I have mine setup so the wires for the X endstop just come out of the front hole on the left side instead of running through the extruder mount to the right side.
To make your life easier, I highly recommend using the nut holder. If the nut is loose in the holder use super glue to hold it in place. If it is tight, heat it up and press it in.
Print Settings
Printer:
Hypercube Evolution
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
.2
Infill:
50
Notes:
I lay this down on its back when printing. You could probably print this without supports but I do it just to have a cleaner end result. Printing this at 60mm/sec with 50% infill takes ~ 4 hours on my evo.
Category: 3D Printer Accessories