Ryobi 18v Trim Router Base Plates
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement base plates for the Ryobi 18v trim router.
- Ocena
- 5 / 5
- Polubienia
- 54
- Pobrania
- 252
- Wydruki
- 1
- Wyświetlenia
- 1410
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I modeled up some replacement base plates for my 18v Ryobi trim router, I made a square version as well as a round version. Additionally I made versions to fit some template bushings I bought from harbor freight
https://www.harborfreight.com/router-template-guide-set-9-piece-59369.html
It may work for other template bushings, here are the dimensions to check:
Hole size dimensions:
Center hole I.D = 1.2 inches
Center hold counterbore O.D = 1.4 inches
Center hole counterbore depth = .1 inches
I printed mine in ABS with 30% infill and .2mm layer height, but I imagine PLA, PETG, ABS, PC, or any reinforced nylons would work just fine as well. Supports are not required for the non-template bushing versions, however the template bushing versions will need supports for the center counterbore. Additionally for the square bases I added little pads 1 layer thick at the corners to help fight against warping for materials prone to warping. The intention was for them to be trimmed off after printing.
*UPDATE 2/4/25*
I added 3 new square baseplate sizes, 5" x 5", 5.5" x 5.5", and 6"x6". I also increased the center hole I.D on these new plates to be 1.75" however these new plates are not compatible with the above mentioned template bushings.
*UPDATE 2/5/25*
I added 3 new round baseplate sizes, 5" x 5", 5.5" x 5.5", and 6"x6". I also increased the center hole I.D on these new plates to be 1.75" however these new plates are not compatible with the above mentioned template bushings.