AFK Virtual Keyboard Dongle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
User initiated right to disconnect in the post covid era. AKA a vkeyboard which keeps you online when working from home
- Ocena
- 4 / 5
- Polubienia
- 39
- Pobrania
- 126
- Wydruki
- 3
- Wyświetlenia
- 1879
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
AFK Gadget
When configured this device makes certain you are showing as always online.
This little USB device will connect to your computer work an emulate a physical keyboard
It will press the tab button every N number of seconds to set your computer status as online. The choice of TAB key is because it will not trigger any actions, not close any windows, and can only interfere with open text editors.
Hardware Required
This design needs the following ultra cheap easily available board.
Digispark attiny85 USB.
lmgtfy App link: https://lmgtfy.app/?q=digispark+attiny85+buy
Print Features
The core challenge is that this PCB is not designed to be encased. The USB -+ data lines are shorter and even the slightest shell will make it not work. Also there is heavy variance in the quality of the PCB you source from various providers as such various tolerances are required.
- Prints in 30 minutes in quality mode
- No supports required
- No screws required
- Clip on method to assemble it
- Various clearance models included, to serve different fillament types. Recommended is 008 clearance for prusament PLA(Please try higher clearance for more funky filament types such as mystique )
- Thick enough to be firm, but thin enough allow the LED to show.
Programming the digispark usb key
Set up arduino build enviroment for your system here
https://www.arduino.cc/en/software
Follow the instructions to install the board & drivers for adudino here
https://digistump.com/wiki/digispark/tutorials/connecting
After this is done you just need to slightly modify the provided example by the manufacturers. Should you wish to just click and program, the program is attached in .ino format.
The arduino needs to be configured to program this board, so make certain it is selected as displayed
Then the programmer has to be configured to micronucleus ( It may be done automatically but please check )
Then the example can be located at the following path
The modifications required in the code are to change the keypress and optionally adjust the period of the keypress to your desired time frame in milliseconds.
Finally after pressing the upload button, the user will be asked to inserT the board into the USB port. If the drivers have been installed correctly, micronucleus will program it and display this message
Celebrate
After the device has been programmed, open a black text editor or word, insert it into the usb slot and verify that the cursor is moving every N seconds
