Sovol SV06 PFTE tube Clamp & Twister Guide for Reverse Bowden Version 2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clip-on clamp/holder with a twister guide for a PTFE tube. Part of a Reverse Bowden setup.
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 144
- Wydruki
- 4
- Wyświetlenia
- 589
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This remix is based on and thus all design credit for the original of Brianne's Sovol SV06 Clip-On Bowden Guide.
The clip-on clamp is the same as the original. The zip tie attachment is replaced by a 2-ear twister guide. The PTFE tube (4 mm outside diameter) can be easily removed by twisting/rotating it a little so it unlocks and can be taken out of the guide through the middle gap.
I use these clamps & twister guides for a Reverse Bowden setup to feed filament from a dry/storage box placed next to the Sovol SV06. It is combined with a PTFE Tube Cage to guide the PTFE straight above the extruder and the mount on the extruder where the PTFE Tube ends.
-------
Update 04jun2024 - Version 2 :
Upgraded the twister guide part, to make it stronger.
The Version 2 (V2) STL provided is the combined clamp and new twister version (for left side). Simply mirror for the right side.
Note: the clamp fits very snug around the Z-axis top mount. You need to push it firmly in place and make sure the ends really clip under it.
-------
Original post - 26may2024 :
I first printed the clamp and twister guide as 2 separate items in Sovol Blue PLA and glewed them together with superglue, after I found the best position that suited the route of the PTFE tube in my particular setup.
Alternatively, you can put the twister guide also on the vertical as well as on the horizontal part of the clamp, depending on your particular need and route of your PTFE tube.
3 STL's are provided: clamp only, twister guide only, clamp&twister combined, so you can choose if you want to glew the clamp and twister guide (or recombine both STL's in the position you prefer before you print) or print the assembly-as-shown at once.
The clamp itself is universal for left and right Z-axis top mount.
The twister guide and assembly have a specific orientation (the STL's provided are for the left side in my case), but simply mirror them for the right side.