Alignment Tool For Delta Tablesaws
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a tool based on the measurements for aligning a delta tablesaw's front and rear fence rails.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 274
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This tool is meant to be clamped to your table saw while you align the front and rear rails for the fence. It is derived from the measurements shared across multiple woodworking forums where this tool is wanted, but not available from delta. Verify thoroughly after your initial setup to ensure your saw is fully functional before use. It contains a spinning death wheel for heaven's sake.
Printed from ASA, but just about anything will do.
No supports
Drawing included so you can see the dimensions.