1 / 3
The Viking Longboat for the lonely alcoholic
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 1 shot holder shaped like a Viking Longboat
- Ocena
- 0 / 5
- Polubienia
- 28
- Pobrania
- 79
- Wydruki
- 0
- Wyświetlenia
- 573
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (22)Powiązane
The filament wasn't dry enough but post clean up did it OK enough. Thanks to the original creators of this and it was a bit of a journey to learn how to edit it in tinkercad as I have 0 experience.
Bit of an obvious joint on the starboard but should do the job anyway.
Generic black and copper silk PLA
15 % infill with hexagon
50 mm/s movement
215 C printhead and 60 C hotbed.
Auto generated supports from Anycubic and a 5 mm Brim for me
Bit rough underneath where the supports were but makes it more authentic to a Norwegian like me.
