1 / 3
1-3 80mm 8025 Aquarium Cooling Fan — zdjęcie 1
1 / 3

1-3 80mm 8025 Aquarium Cooling Fan

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cooling Fan Holder for 8025 Cooling Fan

Ocena
0 / 5
Polubienia
14
Pobrania
146
Wydruki
1
Wyświetlenia
587
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is a holder for 8025 Cooling fans.

The bracket and screw works with all glass from 2-13mm.

Each Holder needs 3 screw to complete the build. 2 Screws are enough if the wire management cover is not used.

1 DC Connector Cover is needed for each cooling fan.

DC connector cover and cooling fan cover are both optional.

BOM (Links for reference)

8025 Cooling Fan - https://robocraze.com/products/8025-12-v-2-2mm-2-wire-fan

Female DC Plug - https://robocraze.com/products/dc-power-female-plug-jack-adapter-connector

6/12V DC Adapter - https://robocraze.com/products/kento-g-12v-1amp-adapter-dc-jack

M4x40mm Screws & Nuts - 

         Screws - https://www.amazon.in/gp/product/B07XDZS8B6/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

          Nuts - https://www.amazon.in/gp/product/B07Z3RX8P2/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

Build Instructions

Print the fan holder (Print height wise to avoid supports) - Check the orientation image to place to print without supports

The Fan cover is optional.

Print 2-3 screws. 2 screws are needed to secure the holder to the tank and 1 screw is needed to attach the wire management cover.

Once cover and holder are printed, place the fan with the wire facing the holding clamp side. Screw the fan with 2-4 m4x40mm bolts and screws. Zip ties can also be used to fasten the fan to the holder.

The wire management cover is optional, if used, route the wire through the given channel and connect to the dc female connector, which should fit in place in the provided groove.

Add screws where needed. Each fan needs 2-3 printed screws.

Do not drop into water.

 

Brings down temp by about 2.5-3 degrees. 

Use 1 fan for every 30-40cms

Tagi