Teachers aid D6
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My sis is a teacher of preK-2nd grade. She wanted a d6 for the kids to roll that doesn't add up to over 10.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 134
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Math
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Sis wanted a 6 sided die that only rolled 1-3 for her kids learning to count. Then after I modeled this one, she told me that the kids don't know numerals yet either. Ha. So pips it is.
I've also added a more closer to normal size die from the super large one.
I've printed the small ones in PLA. Both 100% infill and 0% infill. The 100% feels very good and solid, but both roll well.
I did see an article that talked about a way to print dice properly. And one of the salient points was that if you remove material from the sides, it should be balanced properly. And I didn't do that here. The numerical model should probably be within statistical variance, but the pips will probably favor landing on the 3 pips. Which means it will probably roll 3 more than the standard 33%, and given the material differences I bet it will probably fall closer to 40% for 3, 33% for 2, and 27% for 1. So I'll have to revisit this model and fix that.
Keep in mind, that if you print between 0 and 100% infill, that depending on your infill type, it will definitely be unbalanced.