1 / 4
Minecraft Geared Lever Switch (Flat switch)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified Minecraft Geared Switch lever to work with flat light switches.
- Ocena
- 0 / 5
- Polubienia
- 266
- Pobrania
- 740
- Wydruki
- 1
- Wyświetlenia
- 7692
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (13)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (249)Powiązane
The installation of this is fairly straight forward but you'll need to use slightly longer screws than the ones that are currently attaching your light switch cover. 6-32 x 1 inch machine screws with a round head should work fine.
- Slide the “RAIL-GEAR” into the “BASE-PLATE”.
- Insert the “KEY” in the “RAIL-GEAR”, it should fit snuggly into it.
- Remove the screws from the existing light switch cover. (You can either keep the cover in place or remove it.)
- Screw the “BASE-PLATE” over the light switch. You'll need to slide the “RAIL-GEAR” up or down to gain access to the screws. Validate that the “RAIL-GEAR” still slides easily, if not try loosening up the screws a little bit.
- Install the “COVER-PLATE” over the “BASE-PLATE”.
- Glue the 3 parts for the lever together (Gear/Handle/Wood)
- To install the lever, place “RAIL-GEAR” and Lever as shown below then use the Pin and Clip to secure it in place.
It works for this type of switch:
Here’s the list of filaments I used to make this:
- Bambu PLA Sparkle Slate Grey
- Bambu PLA Sparkle Onyx Black
- Polylite PLA Steel Grey
- Bambu PLA Matte Dark Brown